Help
1-PPR TYPE
Create a PPR pipe type pipe and create a new Segment. Create your own fittings.
PPR pipe type uses own diameters.
Used only in the metric system.
In order to create the PPR pipe type, the standard pipe type must be loaded in the
active document. Duplicates the fittings of the standard pipe type.
2-BLACKIRON PIPE TYPE
Create a BlackIron
pipe type pipe and create a new Segment. In order to create the BlackIron pipe
type, the Chilled Water pipe type must be loaded in the active document.
Uses threaded fittings
up to 2 "pipe diameter, welded
fittings for diameters greater than 2"
It takes the welded fittings from Chilled Water pipe type. It loads the threaded fittings from
the families in its own folder.
3-DUCT HANGER
The console draws only the horizontal and rectangular air ducts.
To draw the console, you need to select an air duct on the floor where you want to draw the console. It only draws on the selected floor.
Console spacing is 1.5m.
If there is a floor above the air duct, the rods extend to this floor.
4-PİPE CLAMP
It only draws
clamps on horizontal pipes.
To draw the clamps you need to select a pipe at the level you want to draw. It only draws on the selected level.
Clamp spacing is 3m.
It is drawn on the rods with the clamp. If there is a floor above the pipes, the rods extend to this floor.
5-SCHEDULE BY PİPE SYSTEM
Whichever pipe you choose , it prepares the pipes on the same floor and in the same pipe system as schedule.
After the command runs, check the schedule list.
6-SCHEDULE BY PİPE TYPE
Whichever pipe you choose , it prepares the pipes on the same floor and in the same pipe type as schedule.
After the command runs, check the schedule list.
7-CABLETRAY HANGER
The console draws only the horizontal cabletrays.
To draw the console, you need to select a cabletray on the floor where you want to draw the console. It only draws on the selected floor.
Console spacing is 1.5m.
If there is a floor above the cabletray, the rods extend to this floor
8-CREATE SHEETS
Create sheets by
taking sheet names in excel.
It only takes the
names in the first column. Names must be written one under the other in the
first column of the Excel sheet.
After the command runs, check the sheet list.
9-COUNT INSTANCES
It counts the family instances you select the same instance in the model.
Comments
Post a Comment